パノラマ写真では3つの失敗をした。ISO感度を固定にしなかったこと、三脚の雲台面を水平にしなかったこと、回転の中心をカメラ本体に合わせてしまったことである。水平については水準器に頼るしかない。高価な水準器も売られているが、Manfrotto 300Nを買ったばかりなので、安価なものを探していた。バブル水準器GITZO GLEVEL 1は量販店で1000円くらいで売られているのを見つけた。
In panoramic photography I was three failure. That it did not the ISO sensitivity to a fixed, that the pan head of the tripod is not horizontally to adjust the center of rotation to the camera body. There is no choice but to rely on the level in the horizontal.But it is also sold expensive level, because only just bought a Manfrotto 300N, I was looking for something inexpensive. Bubble level GITZO GLEVEL 1 had been sold in about 1000 yen at mass retailers.
GITZOの製品カタログにはセンターポール下端のフック部品を取り外し工具なしで取り付けられるとあるが、フック部品が付いてないので、クイックリリースプレートGITZO GS2370LAに付属していた3/8"のツマミ付ネジで取り付けた。
安価なので水平の精度も低かろうと思っていたが、わずかな傾きも検知するようだ。バブルの動きが遅いので、バブルの動きに合わせてゆっくりと調整する必要がある。
The product catalog of GITZO, it is written to be attached without tools to remove the hook part of the center pole lower end. The product catalog GITZO, it is written that it can be attached by removing the hook part of the center pole bottom end without tools. However, since in my tripod it does not have a hook part, I was attached with 3/8 inch screw that shipped with quick-release plate GITZO GS2370LA.
I had expected it would be a low horizontal accuracy because it is inexpensive. In practice, however, it seems to detect a slight tilt. Since the movement of the bubble is slow, it is necessary to slowly adjust to the movement of the bubble.
Level is not not interfere, even folded the tripod.
The GLEVEL 1 was attached to the lower end of the center pole.
コメントをどうぞ
※メールアドレスとURLの入力は必須ではありません。 入力されたメールアドレスは記事に反映されず、ブログの管理者のみが参照できます。
※なお、送られたコメントはブログの管理者が確認するまで公開されません。
※投稿には管理者が設定した質問に答える必要があります。